This is a great boundry Mic that has never been used. I bought it for a special project and never used it. - Bob -
Here's the tech info...
and the Manual is Here
The C 562 CM offers the inherent features of a boundary layer microphone: 6-dB higher sensitivity and elimination of comb filter effects when mounted in a large reflecting surface. Its response is uniform to 20kHz, and the polar pattern is omnidirectional. A-weighted signal-to-noise ratio is a remarkable 78 dB.
The microphones small size makes it ideal for flush-mount installation in any plane surface in a performing environment, including ceilings, walls and stage sets. Its 10 ft. (3 m) attached cable terminates in a 0.125 in. (3.5 mm) male jack, which fits through a 0.5 in. (12.7 mm) mounting hole. An accompanying phantom power adapter provides an electronically balanced low impedance output via a 3-pin XLR-M connector.
Features
- Small & inconspicuous
- Wide frequency range
- High sensitivity
Specifications
- Transducer Principle: Condenser pre-polarized
- Frequency Range: 20-20,000 Hz
- Polar Pattern: Omnidirectional
- Sensitivity at 1,000 Hz: 25 mV/Pa (-34 dBV)
- Equivalent Noise Level: < 16 dB-A
- Sound Pressure Level for 1% THD: 130 dB
- S/N Ratio (A-weighted): > 78 dB
- Electr. Impedance: < 600 ohms
- Load Impedance: > 2000 ohms
- Power Requirement: 9-52 volts phantom power
- Connector: 3-Pin XLR-type
- Finish: Satin nickel
- Size: 0.8 in.dia./1.1 in. length (20 mm dia./28 mm length)
- Net/Shipping Weight: 1.1/6.9 oz. (30 g/195 g)
- Special Features/Applications: Boundary layer microphone
- Included Accessories: Phantom power adapter